Now I have the idea for a magnetic dowel system to position the terrain the base modules need to have holes drilled in them. This array of holes is used to pin the terrain into the plywood with the dowels.
I intend on using 6mm diameter magnets and wood dowels for the job as a starting point. It is prudent to start with small holes and make them bigger if stronger magnets are required. I am also starting with a 50mm array of holes and the module will fit a 23 rows and 11 columns with this array size making a total of 253 holes.
Rather than mark out the array on the module using a pencil and a straight edge I have decided a little more accuracy is required, so back into the CAD system and a quick layout was generated for half the hole array that can be printed to a B1 sized layout. If you want to follow along at home a PDF of the hole pattern layout will be available on the printables page. You can get this printed anywhere that does roll size plan plots. I had mine done at Officeworks here in Australia but there are many place around the world that do it such as ‘Fed-Ex Office ‘ (Kinkos).